|
Pampanga Hobby shop
HOME
 All of our products comply with international quality standards
"Gasoline boat""Gasoline Airplane"Nitro Airplane ARFElectric Airplane RTF
"All Item Are Freeshipping Anywhere in the philippines"!!
ASP 4 Stroke FS120AR Engine
10,700.00
Displacement:19.96cc
Bore: 30.40mm
Stroke:27.50mm
Power:1.6kw/10,500 r.p.m
Weight: 888g
Practical: 2,000-10,500r.p.m
suggest propellar:16*10-17*8inch
  Yak 120 ARF 12,500.00 in stock
Wing Span: 69.2in/1760mm
Wing Area: 960sq in/62sq dm
Flying Weight: 10.0lbs/4570g Fiberglass
Fuselage Length: 66.2in/1684mm
Engine Required: 2C 0.90 cu in ; 4C 1.20 cu in Spe 26cc engine
Radio Required: 4 Channels, 5 Servos
P = 13,700.00 with spe 40cc 22,500.00
Name： Giles-202
Kit No： AG020
Wing span： 75.9in/1930mm
Wing area： 66.2sq.dm
Length： 70.4in/1790mm
Elucidation： Flying weight:4800-5300g;
Engine:2cycle 108-160,4cycle 140/40-50cc Gas;
Radio:4channels 6servos
|
P = 14,850.00 with Dl50cc 28,000.00
Katana |
|
AG009 |
| Wing span： |
80in/2030mm |
| Wing area： |
79sq.dm |
| Length： |
70.8in/1800mm |
| Elucidation： |
Flying weight:5700-5900g;
Engine:40-60cc Gas;
Radio:4channels 6servos |
 P = 12,000.00 with spe26cc engine 20,980
Name： EXTRA-260 Numbers： AG037
Wing span： 69in/1754mm
Wing area： 58.2sq.dm
Length： 61in/1550mm
flight weight:3800-3900g, Engine: 2 cycle 90-120, or SPE26cc Gasoline engine， Radio: 4 ch
5 servos
4CH RTF Plane CESSNA TU206P = 8,500 RTF
Wingspan: 1080mm Fuselage Length: 965mm
Height: 306mm
Wheelbase: 206mm
Tread: 206mm
Motor: Brushless motor (outer rotor) with 20A speed controller
Prop: 10X4.7
Battery: 7.4V-1300mAh Li-polymer
Radio System: 4 channel PCM radio, micro servo x3pcs
Flying Weight: 550g
Flight Time: About 10 minutes
Front wheel steering
With built-in navigation lights Packing Details:
1>Q'ty/Ctn: 5pcs
2>Carton Size: 115*53*98cm
3>Gw/Nw: 20.5/18kg
P - 8,700.00 4CH RTF Plane Pitts S-2A
upgrade with brushless motor
1.Motor:KV950, 2830 out-runner brushless motor
2.ESC:18A brushless speed control panel
3.Battery:11.1v, 1200 MAH
4.Charge:12.6v, 1000 MAH
After upgraded, the capability will more remarkable.Basic Parameter
Upper wingspan:880mm
Down wingspan:840mm
Fuselage overall length:790 mm
Weight:620g 21.87OZ
Wing loading:26g sq.dm
Wing area:24 sq.dm
New !!!!
Wing span£º 70.8in/1800mm;
Wing area£º 63.44sq.dm;
Length£º 53.9in/1370mm;
Flying weight:4000g; Engine:2cycle 90,4cycle 120; Radio:5-6channels 6-7servos; fiberglass fuselage ;
 Wing span£º 59.06in/1800mm;
Wing area£º 47sq.dm;
Length£º 43.63in/1330mm;
Engine:2cycle 46 twin engine powered; Radio:4channels 7servos;
New !!!! Wingspan:790mm
Length:988mm
Flying Weight:600g
Wing Load:47g/dm©÷
Wing area: 12.8dm©÷
Radio System: 4Ch Tx and 6 Ch Rx ,Four 9 gram servos
Brushless Powered: Powerful 15L inner runner brushless motor and 25A ESC
Battery: 3 Cell Li-Po Battery,1300 mAh,11.1V
P= 1,400.00 in stock
The 8A-UBEC is a switch-mode DC-DC regulator supplied with a 2-3 cells lithium battery pack and it outputs a consistent safe voltage for your receiver, gyro and servos. It is very suitable for RC helicopter (above 30 class) and big fixed-wing aircraft.
Compared with the linear mode UBEC, the overall efficiency of the switch-mode BEC is much higher, so it can extend the working time of the receiver battery pack, and because a switch mode UBEC can significantly reduce the heat emission, it can avoid the loss of control caused by the over-heat problem which is frequently happened with the linear mode UBEC.1 Specifica
1.1 Output Voltage: 5V or 6V (Changeable with an output-voltage select switch )
1.2 Continuous output current: 8 Amps
1.3 Burst output current: 15 Amps
1.4 Input: 6V-12.6V (2-3 cells lithium battery pack)
1.5 Quiescent current: 60mA
1.6 Size: 42mm*39mm*9mm (length*width*height)
1.7 Weight: 34g
2 Features
2.1 Designed with an advanced switch mode DC-DC regulator IC.
2.2 The output current is very large.
2.3 With the output short-circuit protection function.
2.4 A metal shield covers almost all the electronic components, and a specially made filter is attached with the output wires to significantly reduce the electromagnetic interference.
2.5 Automatically detects the number of the lithium battery pack (2 cells or 3 cells).
2.6 Shows the battery capacity with 4 indicators (LEDs).
2.7 Shows the working status with an indicator (LED), lights when the output is in normal range.
2.8 There are 2 output leads to reduce the resistance when connecting the UEBC to the receiver.
|
|
